Search results

I need some motor advice. I’m looking to swap out my factory block for a built motor. I have a v7-ysi supercharger and other bolt on mods, running a 2.9 pulley, and a built 10spd trans to support that. I’m making about 19-20lbs of boost right now and looking at probably high 900-low 1000whp. I...

I have a 10r80 trams rebuilt with a suncoast stafe 2 transmission, dual pump fore fuel system, v7 ysi and corsa full exhaust, Lund tuned for e85 on a small pulley. The issue I’m having is that as the trans fluid temps warms up, it jerks between gears and surges in certain gears and you can see...

What front drag springs would give me clearance on my 18x5 front skinnies on 28x4.5-18 tires?

So last night while cruising out of a residence, when pressing the gas the car wouldnt move. I stopped, turned it off then turned it on again. When I did this and put the car into D, the gears jumped to 10th gear and back to 7th all while being stationary, the car didnt move at all. The only...

So I have a vortech v7 ysi 8 rib kit on my '20 gt pp1. its running a 3.25 griptec pulley and the current engine mods are MMR Billet Oil Pump Gears and crank sprocket as well as NGK 6510 spark plugs. ID1050x injectors and a Sai Li fuel system. On the stock 3.6 vortech pulley and an e85 Lund tune...

So I have a vortech v7 kit on my '20 gt pp1. its running a 3.25 pulley and the current engine mods are MMR Billet Oil Pump Gears and crank sprocket as well as NGK 6510 spark plugs. I had an issue before when I installed breather filters on my driver and passenger side pcv valves, the driver side...