Search results

Takeoffs from a 2018 PP1, these are the upgraded Nickel Forged wheel option. Tires are in excellent condition. Front tires are Michelin PS4’s and rear are Kumho Ectsa Sport A/S Located in Biloxi MS

Going to get the car on the Dyno soon but wanted to see what people think it will put down. 2015 GT with Beefcake special stage 2 Paxton 2200 with max 57 bov, car sees 15.5-16.8 lbs of boost on 93+Octanium with the higher number being prevalent in the winter. Also have LTH’s no cats, Corsa sport...

So today I think my 6R80 died, I was accelerating from about 70 and when my car went to shift around 120 mph the transmission just slipped. I was able to pull over and put it into park and shut it down. Started the car and I could drive again but when I reach third gear it just slips around...

Boosted my car just recently with a Paxton Novi stage 2 Beefcake special (max 57 BOV, 3.6 pulley), added ported 2018 intake, comp cams stage 1 blower cams,JLT CAI, SS long tubes, Corsa cat back, cat delete etc. currently running a 93 Lund tune and wanting to squeeze a little more out of it. Do...

Looking for a 2018+ engine cover

Does anyone know the diameter of the centercap used in the MMR M600’s?

So I am installing a set of Comp Cams stage 1 blower cams and have a question. I am Using the Ford manual to set them up and it appears that the left intake cam and the right exhaust cam are sitting a little proud when setting the caps on. These two cams also can not be rotated by hand when in...

So I have decided to do Cams, ARP head studs, MMR boosted head gaskets and new valve springs while I have my motor apart. Looking at everything it appears the heads could possibly be removed while the motor is still in the car. Has any one had experience doing this and if so any tip to be had?

So I just installed OPG’s yesterday and when reassembling the housing I just fingertightened all of the torx screws and then using a criss cross pattern snugged them as tight as I could with a 1/4” ratchet. I was watching a few videos tonight preparing to reinstall the chains and I noticed a...