I have a 2016 Mustang GT. I have a low RPM rattle. This is a 5.0 with a manual transmission. So it is an MT-82. It has a McLeod Lightened flywheel and the RXT clutch. The noise is either the engine or transmission. It seems to emanate from the trans but thought I would see if anyone else...
I have a DSS aluminum shaft in my car (2016 GT M/T). It was a 2019 build shaft and has well under 10k (close to 6k) miles on it. The rear cv already has noticeable play. It clicks when I twist it. I compared against a new good one and its is different. It also tightens up when I compress...
I have read through a ton of posts about the runout on the 15-17 pinion flanges. I see the automatic got updated to improve tolerances and concentricity to reduce runout. I see that there is a new revision number for the 15-17 manual trans flange. Can anyone confirm that FR3Z-4851-B would...
I am trying to figure out how much play I should have in my driveline. Right now I would consider it excessive, but its my first mustang. With the car on the ground, transmission in first gear, I can move my car forward/backward a total of 2-1/8". This is a gentle rock until the play is taken...
I have a 16 GT that rattles at the ball and socket connection on the driver's side behind the cat. The clamp is tightened down all the way to the point that the clamp halves are touching. What is the best solution to fix this?
I am running stock manifolds and cats. Aftermarket x pipe and...
I have a 16 GT PP with a KB SC kit. I am running a Sai Li fuel system for E85. I have a remote tune done with data logging. One of my problems I have is that I have terrible throttle response, especially when warm. If I stab the throttle it bogs quite badly. It takes about a second for the...
So, I have a 2016 GT PP car. Clutch was dragging some of the time. I bled it out, and it seemed to be ok for a couple days. Then it would start acting up again. The clutch and throwout are only 6 months old. Less than 5k miles. I pull the transmission, and the throwout bearing makes a...