Sponsored

Search results

  1. whipple flight controls

    You have flight controls on a 2018 Whipple tune....what version is your tune? Thanks, Rob
  2. Another Gen 5 whipple thread .

    I got this from the HPTuners Forums. Thanks to LastPlace for the information. TQ_CNTL source: 0 - Driver Demand 1 - Transmission Torque Truncation 2 - Traction Control / Collision Mitigation By Braking 3 - Vehicle Speed Limit 4 - Engine Speed Limit 5 - Tip-In Management 6 - DFSO 7 - Shift...
  3. Looking for TQ_CNTL(SRC) PID source table

    Looking to find the corresponding source for the parameters for the TQ_CNTL(SRC) PID. In help is greatly appreciated. It is for a 2018 GT. Thanks in advance, Rob
  4. 2018 GT Whipple Stage 2 - Mustang Dyno Results

    Based on the above quote it appeared there was a starting issue plus limp mode had the car sent to Whipple. Rob
  5. 2018 GT Whipple Stage 2 - Mustang Dyno Results

    What was the cause of not starting here? Thanks, Rob
  6. 2018 Whipple Stage 2 A10 Tune Versions

    Also you can put the Tomahawk SD card on a PC and look at the .bin file on it. That is the tune file. The filename has the version in the name. Rob
  7. FS OEM 1/2 Shafts - 11miles!

    Still available. $175 shipped. Rob
  8. 2018 Whipple Stage 2 A10 Tune Versions

    Update.... This latest tune is very good. Driving around for about 60 miles yesterday it was very OEM like. I give it a big thumbs up :thumbsup: for daily driving with power on tap. Trans shifts are smooth and finds the right gear as needed. Whipple's effort on the tune development is...
  9. 2018 Whipple Stage 2 A10 Tune Versions

    Got the latest tune from Whipple. A note came with it that indicated that a feature added is that it would reduce power if the air charge temp sensor was not connected to the correct IMRC connector. Earlier versions of the install manual called out the wrong wire colors for the IMRC connector...
  10. FS OEM 1/2 Shafts - 11miles!

    Sent PM
  11. FS OEM 1/2 Shafts - 11miles!

    Still have these. Best Offer... Hate to just throw these out. Rob
  12. MMD Painted Hood Vents for 2018

    It is a stock grill, upper and lower. However, the chrome pony was replaced with a black pony. Rob
  13. MMD Painted Hood Vents for 2018

    They will not fall off. There are bolts and 3m tape to secure them to the hood. No drilling required since the bolts use the factory holes. As a result the OEM vents can be reinstalled and no evidence that they were removed will be left. Thanks for the good words. The color is actually...
  14. Ceratec

    In the 2018 GT with Whipple it definitely quiets the engine. I did not notice a tick of any kind prior to Whipple or after. So can't say anything about how it impacts a tick. As an aside I put about 3/4 of a bottle in our 2013 Ford Focus. No change in noise(quiet already) but the average...
  15. 2018 Whipple Stage 2 A10 Tune Versions

    So what's the latest A10 Whipple tune version? Is it beyond 2-5? Thanks, Rob
  16. 2018 GT Whipple and still waiting

    Congrats! Just be careful because that rocket can get sideways in a flash..... Enjoy. Rob
  17. Finished the set up, was driving great- now a nasty fuel leak

    Not sure if you are aware but the retaining ring for the hat is not in the locked position. Looks like you have to remove the ring but it should lock in the middle position of the of the retaining bumps. Where it is now it would eventually have come completely unlatched, you think you have a...
  18. 2018 GT Whipple and still waiting

    FYI, the trans fluid has to be at operating temp to check level. Rob
  19. HPT nGauge Model Selection not Showing 2018 - 2019 Mustang

    Moderator, This thread should probably be moved to: V8 5.0L Engine / Mods: Bolt-ons, Exhaust, Tuning My bad, Rob
  20. HPT nGauge Model Selection not Showing 2018 - 2019 Mustang

    The closest I got was the 2018 F-150 5.0L with TM298. The nGauge is updated with the latest firmware. Should there be a 2018 - 2019 Mustang 5.0L choice? TIA, Rob





Top