Search results

Great info as I have finished the install of the Stage 2 kit and just wanted to cover all the bases before letting her rip.

Thx for the reply and info and hoe you get heathy soon.I am wondering if anyone else had this problem running the Stage 2 with the Edelbrock 93 octane tune as this is what I am planning on doing.

What has Edelbrock said about this issue/theory.

Was wondering Dalton if you have the results from this install.

Sorry hit the wrong key. The supercharger manifold includes a 1/8 NPT port to accommodate the installation of a boost gauge or pressure transducer. Remove the plug and replace it with a fitting to attach your gauge or sensor.

1/4'' fitting

Interested in results on 93 pump with stage 2 parts.

I beleive Heinz's car is Running E85 and Custom tune as stated by Terry in another post and I would like to know what other mods ie headers - suspension ect are on this car.I am curious to see what a Bone stock 18/19GT with the Stage 2 kit can do in good conditions with pump gas on Edelbrocks...

The tips are from Go Rhino part number GRT3410B.I cut them to the desired length and used 2 strips of header wrap on each factory tip to create a tight fit.I drilled and tapped 2 holes in each tip and used allen screews which tighten into the header wrap.There is about a 1/8 of an inch of space...

Here is my fix.took a little time to find the right tips as the originals are oval not round.Then figured out away to stop an vibration using header wrap and then off to powdercoating and I used allen screews to hold in place

The hesitation/Bogging is due to the nannies when running the stock tune.The torque management kicks in and ruins the run

The rubbing is caused by the Disc being out of round it's a simple fix as stated above and explained in the instructions which most men and all mecanics never read.I had a friend have them installed by a Professional mencanic and the guy didn't even rotate the wheels before setting the car back...

Here is CM Rollbar installed in my 2019 GT.Excellent fit + finish.

Great runs 8's are on there way!

Rear seat delete is the formed carpet model (similar to the GT350R ) and the 4 point rollbar is from Competition Motorsports.Excellent quality and finish.

Here some pics of my winter project.

Well I figured it out and the seats are installed and everything seems fine although I can only drive it around the parking lot until spring.The passenger side seat sensor works as we used the original wiring harness and bladder and added the 2.2ohm resitor to the Seat side airbag plug on both...

Here is the way Ford says to reprogram it after replacing the mufflers.Hope it helps but it sounds like you have an intermitent problem and those are the worse.

You should check both fuses first and if blown replace and if the go again then check the wiring.

Yes it's the Roush kit re-branded as with 2015-2017 kits