Search results

Vland red sequential 5 mode rear lights for S550 '16 onwards. 12 months old, mint. £300 plus post.

Fitted front pair recently and can't fault them.

Hi, has anybody coded their Vland rear lights off the car? Reason being that I have Rtr grill lights on first click on light switch which is used for programming Vlands and I think the leds are not using enough power to trigger the coding sequence( I've tried lots).

Just thought there maybe some install pictures or any help with .. oh hang on...nevermind

I've used Ford insure for a couple of years now, hopefully won't have to find out how good they are but so far they are competative with the mods i have for the money.

Any suggestions for reclining bucket seats on personal experiences? I'm thinking of replacing my standard seats with Corbeau RRS? Any experiences , thanks in adv.

275s will be fine , 255 is just my personal preference, not stretched in my opinion. :thumbsup:

Long story, i initially thought 275 was the way to go even though my previous Hankooks were 255, when i then ordered some yoko 275s they just looked silly wide for the front so i re ordered 255s. I know 255 to 275 are recommended but the 255 just look correct on the rim for me. Mine is lowered...

Hi, I have RTR tech 5 20 x 9.5 and 10.5. I have had fitted last week Yokohama 255 35 20 front and 295 35 20 rears. Tyre fit is spot on, had the wheels a few years with these sizes and are spot on. PS, i had Hankook before these and was well impressed, only went Yokos as i think they are...

I'll second Nemesis

I went from red to light grey with red brembo transfers

Really happy with how the install went. I've put a few hundred miles on her now and all temps are normal . I've been putting some old lino under engine bay to check for any leak, none at all :thumbsup:.

Hi, recently fitted a new pair of Mtec c hook discs/rotors. Thing is, the pads aren't covering the inner part of the disc, is this normal. Double checked these are the correct discs. I'm using standard pads. Surface rust obviously shows missing area from pads.

I routed them from the take off plate along the same route as the original coolant hoses, under the ARB, under the rad and straight to the cooler. I found this the simplist route and the oil lines don't touch anything.

Had a day off yesterday, woohoo, so I finished th install. As I was doing this I changed oil and filter. I had let the engine oil drain out for a day so it had a good change. I refilled with 8.5 litres of oil which brought it up to middle of dipstick mark so I will let it settle for a bit to...

Yes, 19mm.

Cheers bud, here's a link for hose. https://www.ebay.co.uk/itm/223929639954?var=522672505584 I've bought a Mocal 235 16row oil cooler, 570-TOP21 thermostatic take off plate , and pre made stainless hoses. As i have it all apart i'm fitting new front discs, camber bolts and uprated ARBs front...

Hi all, so i have started on the oil cooler upgrade. Bumper etc off and drained coolant. I removed lower coolant hose and fitted a samco u bend hose to block off original route to OEM cooler.I found it a lot easier to remove hose than fitting it underneath. I'm going to take my time so will put...

Hi, i changed my Roush axle backs (single exits) to 4 inch quads. I trimmed the valance as careful as poss, really pleased with the look.