Search results

Ridetech was always in!!!!:)

Sticker-less Project 6G is stickerless and ready for big changes for next season. Who wants to be a part of the 2017 season...we will see! #dusolddesigns #project6g #ridetech #hptuners #BMR #forgestar #bfgrivals #baer #sparco #*********** #vorshlag #magnusonsuperchargers #Gloc_brakes

Right around .75

I run 650s in the rear and do not have any problem getting into the bump stops. But I am not sure I have the same internals in my Ridetechs.

Stock motion ratio .48

Magnuson Supercharger In addition to the repairs we made, the Magnuson Supercharger is back on the car and ready for some more track tuning!

I can only assume it was repeated lateral loads we were putting on it. I would keep an eye on axle nuts to make sure they stay tight. Other then that, I don't really have any ideas, this car has seen a lot of track and Autox miles!

It turns out the Torsen was fine! We were chasing two problems that just happened to occurre at the same time. The ABS problem was caused by a "egged out" axle spacer, that allowed the axlento move just enough to freak out the ABS sensor. The noise in the rear end was actually coming from the...

SEMA and OUSCI Well...the car got a lot of attention at SEMA, but unfortunately that was the highlight to the week. During the first event of OUSCI the factory Torsen decided to give up the ghost! Can't complain though, it did last over 8000 miles of track and AutoX thrashing. It did mean we...

SEMA 2016 The car is posted up in Optima Alley for the week and the. It's off to LVMS for twos days at racing! It's going to be a fun week!

Looks good. I will have to come by and check it out.

SEMA Well the car is at SEMA and chomping at the bit to go racing this weekend at OUCSI, but this is the real world, and not everything goes as planned! I had to leave the blower on the bench at the shop, which means we will not have the intoxicating power for the road course at LVMS. The...

Check out the interior Flare I did for OUSCI at SEMA on my Facebook page! https://www.facebook.com/Progect6G/posts/1792898290979665:0

BMR Motor Mounts The SEMA crunch is here and I finally got some time between tuning and data logging, to install the BMR motor mounts, that allowed me to lower the Coyote.5 inches. The blower install only added 32 lbs but it is all up top, so lowering the motor will lower the CG and hopefully...

MCS Coilovers! Selling My MCS coil overs from last season. They are great shape and come with springs and rear mounts. You will need to supply camber plates or I can sell you a new set of Vorshlag camber plates, so they will be ready to bolt on. The spring rates are for Track day and Autox use...

Selling My MCS coil overs from last season. They are great shape and come with springs and rear mounts. You will need to supply camber plates or I can sell you a new set of Vorshlag camber plates, so they will be ready to bolt on. The spring rates are for Track day and Autox use but can be...

I appreciate when people recognize my references! :)

Looks great! I could use some of your Fenders for D&E points in OUSCI at SEMA!

Doing some interior "Flare" for added D&E points at the OUSCI! SEMA, here we come me!

John's car is awesome!