Hi all, I've experienced rear inner axle boot failure (closest to diff) on the left hand-side of my whippled 2020 Mustang GT Coupe. Most likely due to the close proximity of the exhaust (wrapped it now with heat insulation tape).
Unfortunately a couple of shops put generic boots on and they...
The usual story been struggling with traction on 35 mph hits (see vid of me pedalling!). Done all the rear BMR and Steeda stuff but H&R coil overs are not working as they’re for track. Trying to have a balance of straight v cornering performance so got some baserka rear shocks. What’s best C & R...
I have a fellow whipple 10R80 Australian owner that recently had a custom tune. On start up the low oil pressure light came on. He indicated that the car idles and sounds fine but didn’t drive it. Nothing is wrong with the car itself as when he loads his other tuner’s tune its perfect no light...
Ok, I really need an honest opinion based on experience. I roll race here in Australia at a legal non prepped race track 35 mph hits to 130-140, and I have to start in 3rd and still pedal for the first 60-70 yards rolling on 305 x 40 x 18 e street ss tyres. Rules are no prior burnout.
My...
I know this is an S550 forum and I have a Whippled 2020 GT, but I’m interested in purchasing an S650 GT but need an indication of when it will be finally custom tunable.
Do any of you believe based on solid evidence that the S650 ecu will be cracked in the next 12 months?
Finally found an awesome tyre 28 x 10.5 x 18 DBR Hoosier that dead hooks my whippled 10R80 2020 GT at 15 psi tyre pressure on a non prepped track. Problem is it hooks too good with rim spinning in tyre. Apart from bead locks is there any tricks I can try to stop this happening when I do my rolls...
As an Australian owner of a Whippled 10R80 Mustang GT with a 1500 hp KPM returnless fuel system I want to commend Wengerd Performance on super 93 (our 98) and E85 tunes all done remotely via rtd3 and TDN set up. The smoothness and drive-ability, and power of the vehicle is incredible and I can’t...
Hi all, I have recently had the KPM 1500hp fuel system installed. It has the 1500 hp rated (for 93 or 98 in Australia) fuel module, 1500 cc injectors and PWM controller. I take it the Whipple fuel rails are fine but have any of you running this kit got the bigger fuel lines or is this not needed...