Recent content by Mwarn84

Yea all in for parts, fab work, and welding I paid about 500. That was with charge pipes and bov as well. Piping route is a bit shorter then running down low too.

Here you go

I will take a pic and upload for you. He made a map flange and drilled a hole in the side of the core. Then I had it welded on to the core.

Pic of core

I'm currently running a cxracing core on my car. Custom set up that my friend came up with and fabbed at his house. Has been working well for the last 7 months, no complaints! I like how it's different from everyone else.

Here is my review of Adam's tune (tune+). I purchased an accessport at about 1k miles when Adam was working for MAP still. It came with a base tune that could be revised one time. I ran that tune for a few months without any issues and it ran well. Once I was ready to get a full tune I went...

I'm actually in Tomball area, right off of 249 near spring cypress. This set up was all my friends design, so thanks go to him! He had one as well but totaled his EBM........and got a different car now :( this requires a bit more fab work. Charge pipes had to be measured and cut, then welded...

I did something similar using cxracing parts. Total cost was in the $500 range for core, charge pipes, bov, and some fab work. I'm happy with the results, been running it for around 5-6 months already. I'm in Houston too!

Muffler shop charged me $10 to weld both side back together lol.

Same thing happened to me. Went to get some exhaust work done at a local shop and saw that the bracket had broken off on both sides. I inspected it and it did not look like there was a hole at all, so I just had them weld the bracket back on.....