Recent content by mbreinin

I am interested in doing one of these, my only real concern is how well this kit is going to hold up over time as this will be on a car that gets driven basically daily, and a good distance. Those low mount Precisions have me somewhat stressed out.

I would assume the #3 rod broke, since that was where the hole in the block resided. LOL.

#3. Motor had 4,000 miles. I was logging late at night in early January 2015 for a track day the next day. 93 tune from Unleashed, JLT CAI, spark plugs. No other mods. Made two clean pulls. Rolled into WOT from 40 and it exploded on the upshift at redline. Windowed the block and I found the...

I have run Rotella, Mobil 1, Castrol and even the Motorcraft blend with either a Motorcraft or Wix filter. My engine has 109,000 miles on it, most of those tuned.

I drove with mine like this for a long time, longer than I care to admit. I was at the point where I could not start the car without adding throttle. I would actually keep it running while pumping gas to avoid the issue. I finally changed it and all is cured. I changed it because, aside from it...

I still have this. I want it out of my shed. Let's go.

It is worth increased HP over aftermarket units. LOL

Modern metallurgy means that engines are broken in within about 5 minutes of being driven. You don't need to break in a turbo, either. I am sure people will try to claim otherwise, since break-in is a topic with differing opinions.

4 of mine are ignition correction, one is boost and one is MAT.

I installed one and since the install I have not seen any of the dreaded burned oil in the exhaust from my catless DP. I had the car idling for an hour and a half yesterday and there was not a single puff. I did not expect that, but it is a welcomed outcome. Much easier than a catch can.

Well, where is your stuff? I assume you have a new HPFP to go with your LPFP setup? Mike

I do. LOL

I asked Adam about this a little while ago and at that time there was no control package available. Not sure about now. I would love to put one in an SVO (I have had 3) or a Merkur XR4Ti (had 2 of those). Mike

Wagon. :D

Well, if you want GT beating performance that is obtainable from other tuners. It is really not that hard to beat stock GTs with a mild bolt on EB. Straight line, of course. The EBM with PP is a superior handling car than a GT.