Recent content by Kzanard

Located just outside of Boston. It is a Whipple 2.9L Gen 2.

Thanks again Nomadic! For those wondering, I spoke to Whipple and they said wasn’t a big deal but they preferred MAF sensor positioned toward the front. Easy fix and done!

For sale is my like new 2016 Ford Mustang GT Premium Package with Whipple Stage II Supercharger package. It still looks, smells, and runs like new. I simply do not use it (*only 6,200 miles!*). Adult owned (I am 51) and never beat on or tracked. Almost every Factory option. Always garaged and...

Thanks for replies. Just placed my order.

Factory Sub Not sure if I missed it, but has anyone asked how it will fit with the Factory sub? Would we need to cut the Mat to fit or is there a removable section (looks like it in some of the pics). Thanks!

New vs current

I am not sure if the exact setting, but Limiting might have been it. Run 1 & 2 were done right after one another and there was surely some amount of heat soak (I don't have fans). Run 3 was done after the car had cooled a little :shrug: i could care less about the numbers as long as the...

Yes and no. The latest shop found that I had one seating in Flight Control set wrong and it was cutting off on the top end (I forgot which one). When they changed the setting, I gained some on the top end. In the attached dyno, it shows: - Run 1: 3.75 with my original settings - Run 2...

lol. Actually, I was very happy with how it was running and it felt very strong. *I also took your advice and went down to a 3.625" pulley afterwards the same day and put down 724/564!

Updated numbers on a dynojet FYI for anyone interested: Had the opportunity to have the car dyno'd on Dynojet with exact same set up as in my original post for comparing to the Mustang Dyno. Results were a little more on par with what I expected. MUSTANG DYNO: 570whp/426tq DYNOJET DYNO...

Wish I knew! This is just around the corner from my house.

Boost reading on dyno What are your dyno operators all doing for monitoring boost level during dyno sessions? The guy I used could not find anywhere to tap into so I did not get a boost reading during my runs.

5th

Thanks for your feedback. I appreciate any additional info/opinions anyone has! Mustang_Lou: What's up with your AFR (black line)? - I am not sure. It is not too bad if you look at the file "kevin_mustang_tq_afr.pdf". it is between 11.0 and 11.9 Angry50: did yall pull...

Just FYI for anyone with similar setup. I had my kit installed back in May and finally had a chance to throw it on the dyno.... My setup is: - Mustang dyno (570whp/426wtq) - Whipple Stage 2 (latest Whipple cal), NO fans - 3.75 pulley - 93 octane - all stock motor (*upgraded OPG & CG) - cat...