Recent content by jd_cobra

Thanks guys! I’ll gather supplies and get it done when it gets a bit cooler here in Houston. For the most part, I adhere to the two bucket method with minimal contact drying so hopefully this takes care of the minor imperfections.

I’m looking for good products that can achieve a good single step correction “detail”. I don’t have much time like used to, and I’m not looking to achieve a show car finish, just something that will get the majority of defects out in a single step. Thanks!

Nothing so far. All I’ve seen are carbon fiber covers and “pull over” covers.

That bad huh? I’ve heard it’s more of a dry heat compared to the humidity here. The cluster read 115° at one point, it’s ridiculous. The heat this summer has been brutal.

mine only made it 3 years unfortunately. I thought the Texas heat would get to it which is why I always tried to keep it conditioned.

I’ve routinely cleaned and conditioned the interior, but it still wasn’t enough for my big ass elbow apparently.

thanks! :fistbump:

Yeah I wasn’t sure. I’ve seen some with perforated grips on the side and thought maybe that’s what that was for.

Looking at replacing my steering wheel and kinda like the look the carbon fiber. Doesn’t anyone have any recommendations for a wheel that has the heated option that works pretty good? TIA

What do you look for the most (besides upkeep with maintenance) that would make you either want to buy, or not buy said vehicle?

If you have it in another week, I’ll probably come scoop it up. In the Houston area as well. Any clips of what it sounds like with the Magnaflow resonator?

Clean car! Glws man 🍻

well I mean I did say CENTRIFUGAL , so there’s that.

3.15 is optimal for centrifugal blowers on these cars

do you have a shifter mount? If you don’t want to add a complete shifter, the mount will help a decent bit with the slop as well. Good luck, hopefully it resolves your issues!