I've sold my 2020 10R80 Mustang GT and have a bunch of power and suspension parts I'm looking to sell.
All parts are located in Houston, Texas for pickup and also available to ship.
All payments will be handled via cash at pickup or PayPal for shipments.
ESS G3 + G3 intercooler + extras -...
I'm not sure how you have your lines plumbed up with both your stock front cooler and your remote rear cooler but I have a remote rear cooler and I use an external thermostat at the outlet of the trans.
https://www.improvedracing.com/high-flow-engine-transmission-oil-cooler-thermostat.html
You...
Don't get me wrong, the G3R is most definitely an upgrade and I'll likely replace my G3 with that if my engine ever pops and I need a rebuild.
On Bill's car it outperforms his G3X in every way.
Was referring to that graph specifically since there's not a lot of information out on it yet except...
Unless I'm missing something that graph seems off.
The hp/torque intersection is different for both units. With the x-axis being wheel speed the G3R was either run in a lower trans gear (higher trans gear ratio) or effective rear end ratio was changed (or entered wrong).
Which also explains...
It's one data point but the fastest and quickest person I'm aware of with ESS' smallest blower (G2 with 100mm pulley running 9.4x @ 149.xx) runs this resonator and has been doing so for over a year.
@kevinvan6000
I have it at the base of the MAF -> TB tube, about 4 inches from the MAF end.
Anywhere on that tube is fine really.
Yeap, I had to cut out a section of the tube (an inch or so) to accommodate the ring and have the tube fit fine on the car.
If you have the standard MAF -> TB tubing get the 3.5", that's what I have on mine.
https://www.nitrousexpress.com/Barb-Water-Meth-ring.asp?childskumatch=SNO-40111-3.5
The 4" will fit the GT350/Bullitt tubing
Looking for FFE with manageable volume, don't like overly loud setups.
You mentioned you didn't see a power difference with the 2.5" borla resonator vs the 3" s-type's X-pipe.
About how much power is your setup making?