Recent content by buzz-dee

Thanks a bunch, I'm fine waiting for screenshots.

I’m having the exact same issue with my swap. Would you mind sharing the AS-Built that made the CTA finally work? Thanks for your help.

Well, I was measuring different connectors and then tried to find them on https://www.mouser.com/ Also fellow German Mustang enthusiast @Falk03 was helping me big time having done his own research in the connector business. I didn’t bother about the mentioned c405 connector, since my fog light...

It‘s really difficult to help, if you don’t provide a bare minimum of information. What model year are you working on. Which steps of the instructions did you already perform? a little more insight would be really helpful

Yeah, i was thinking so too! But both failing simultaneously seemed a bit unlikely to me

Strange, the only things that come to my mind: make sure your CAN wires tap into the correct circuits CAN polarity correct? CAN wires shorted to ground by mistake? orher than that I’m running out of ideas

When you fire up forscan, make sure to NOT load your previously stored vehicle profile. Create a new profile when asked, it’s slow but that way forscan will scan your CAN bus for any modules present. If your wiring is good, both modules should show up. From your pictures I can’t tell for sure...

I don‘t remember, sorry! But I could offer you to send you my asbuilt file so you can start from there and compare it to your settings

Left or right doesn’t matter. One of the modules (right hand side) wirings has two ground wires instead of one. That way the module itself „knows“ which side of the vehicle it is located at and will identify itself on the can-bus accordingly.

I realized the car would lock me out of TrackApps as soon as a push the Cruise Control „on“ Button in the steering wheel. As soon as I switch off CC it will let me access the trackapps again.

if you slam the brakes hard enough, all the brake lights (3rd included) will flash rapidly and keep flashing as long as you keep the pressure on the brake pedal. I’m not completely sure about the hazards...I believe they do only come on once you’ve stopped completely. Wether the brake lights...

Actually it is possible to enable the emergency brake lights. The Euro Spec Mustangs MY15-17 have it enabled from factory. Not sure about MY18+ Using Forscan look at the following address in your BCM: 726-26-02 xxxx x*xx xxxx you should have a zero in that spot. Change it to 1 and the...

Someone here on the forums tried that a while ago and was not successful.

hi Tim, yes you’re right. You also need the terminal for the c2280b connector. I’m not sure if one of those you ordered will fit in that connector. According to our German forum it should be mouser # 1924955-x (the x could be 3, 5 or 7). But take it with a grain of salt and better look that up...

not sure what you mean by SBC, the BCM behind the passenger kickpanel gets powered through several fuses from the Power distribution box in the engine compartment. it detects your light switch settings and Fog light button press and then sends 12V from its internal power supply to the pin 25...