Left or right doesnāt matter. One of the modules (right hand side) wirings has two ground wires instead of one. That way the module itself āknowsā which side of the vehicle it is located at and will identify itself on the can-bus accordingly.
I realized the car would lock me out of TrackApps as soon as a push the Cruise Control āonā Button in the steering wheel. As soon as I switch off CC it will let me access the trackapps again.
if you slam the brakes hard enough, all the brake lights (3rd included) will flash rapidly and keep flashing as long as you keep the pressure on the brake pedal.
Iām not completely sure about the hazards...I believe they do only come on once youāve stopped completely.
Wether the brake lights...
Actually it is possible to enable the emergency brake lights. The Euro Spec Mustangs MY15-17 have it enabled from factory. Not sure about MY18+
Using Forscan look at the following address in your BCM:
726-26-02 xxxx x*xx xxxx
you should have a zero in that spot. Change it to 1 and the...
hi Tim,
yes youāre right. You also need the terminal for the c2280b connector. Iām not sure if one of those you ordered will fit in that connector. According to our German forum it should be mouser # 1924955-x (the x could be 3, 5 or 7). But take it with a grain of salt and better look that up...
not sure what you mean by SBC,
the BCM behind the passenger kickpanel gets powered through several fuses from the Power distribution box in the engine compartment.
it detects your light switch settings and Fog light button press and then sends 12V from its internal power supply to the pin 25...
Thatās ugly!
the output pin 25 is driven by a transistor. Usually those are overload and short circuit protected. So hopefully you didnāt fry it.
do you have FORScan available? If yes, good. If no get ForScan and an appropriate adapter or find someone who can help you out.
Using ForScan, Go...
Did you have it working before and now thereās no power to the pin anymore or are you still in the process of activating that feature? You have to make the proper asbuilt changes in the BCM, otherwise the circuit will not power up at all
Installed a 2018 analog cluster in my 15 GT PP lately. It gave me some headaches at first. Odometer could not be adjusted though forscan says it can be done on a 2018+ cluster. Turned out that you really have to use the latest build of forscan for success. I was able to change the odo just fine...
i donāt think this is possible through ForScan. The BCM will only power the rear fog when the button is pressed AND the headlights are on. (as it is demanded by law in Germany for example)
Why would you want to have it always on? Itās quite dazzling for the one traveling behind you...
I think the MyColor info is being sent by the IPC, thatās why it started to work on randy_thoās car when he put in the premium (lcd) cluster. I also believe that all the signals for the different gauges are already present on the can bus. Therefore the gt350 gauges show temp values while in the...
several steps are involved in your project:
you need to get wiring terminals for connectros c205, c2280B and c2280C.
for c205: https://www.te.com/deu-de/product-2098762-3.html?source=header-match
for c2280C...