Recent content by AmpedUp

Not a pro by any means. I am using the following from Chemical guys on my magnetic grey Hybrid V7 for wash http://www.chemicalguys.com/Hybrid_V7_Car_Wash_Soap_16oz_p/cws_808_16.htm Black Light for glaze http://www.chemicalguys.com/Black_Light_Hybrid_Radiant_Finish_16_oz_p/gap_619_16.htm...

You could also try a magnet, only $35 bucks. http://www.walmart.com/ip/22664792?wmlspartner=wlpa&selectedSellerId=0&adid=22222222227016963626&wl0=&wl1=g&wl2=c&wl3=43538996792&wl4=&wl5=pla&wl6=83260282352&veh=sem

Thank you for the part number!:thumbsup:

Thanks for this! My work boots are hell on my door panels.

Perhaps including a brief description of the term murdered out in common usage as it pertains to black vehicles? http://www.urbandictionary.com/define.php?term=murdered%20out&utm_source=search-action

This is my story too.:thumbsup:

Yeah some experimenting for sure. I wanted an H-pipe to begin with but the muffler guy talked me into the X-pipe. For what it is worth I think just the Roush axle backs are pretty much on point for sound all by themselves. If you do put in an H-pipe I would love to hear it.

Stock set up with an X-pipe. My thread on it http://www.mustang6g.com/forums/showthread.php?t=23925

I did a write up in the DIY section on how to modify the bracket so you did not have to mess with the air dam, but whats done is done. http://www.mustang6g.com/forums/showthread.php?t=14670

Link is to exhaust video? <-----this one maybe? :thumbsup: Did you have to deform the air dam?

Seems like the safest place to park is right next to the cart return as there are no carts to be found nearby.

Not a big fan of the forward tilt the plate has, i was tempted to try and bend it back but was afraid I might snap the spot welds on the rods. Tools I used for cutting the bracket was a hack saw and a Dremel w/ cutoff wheel for the rods. If I get some more time I may end up cutting the rods to...

Ok all done. 1. Cut .350 inches (or just back to the spot weld) off of the narrow end of the bottom bracket. Dress up the edge with a file or some sand paper and black out the raw edges with either spray paint or black Sharpie. 2. Drill a new hole in the center of the bottom bracket about 1...

The real problem is no one makes an x-pipe for the V6 so you will need to have it custom made. I ended up putting the stock resonator back in because it was way to loud when I swapped out the stock mufflers to the Roush AB's. Boostedstang15 has a pretty good vid on youtube that shows the...

Has anyone thought about just installing the lower bracket 180 from pictured? Drilling a new dimple at the correct spot on the opposite rod for the detent to sit in? Perhaps trimming the lower bracket back oh say about 0.350" just back to the leading edge of the spot weld. I think I will...