Pwr roush 2650 intercooler brick results?

[Scuba420]

Has anyone actually gotten the pwr roush 2650 brick and what are the results. I don’t wonna go chiller because I live far north running vmp heat exchanger and lower temp thermostat curios to the recovery time improvements

Sponsored

 

[Cory S]

Has anyone actually gotten the pwr roush 2650 brick and what are the results. I don’t wonna go chiller because I live far north running vmp heat exchanger and lower temp thermostat curios to the recovery time improvements

What is it you’re trying to achieve? Is your IAT’s high enough to pull timing back during WOT?

 

[Scuba420]

What is it you’re trying to achieve? Is your IAT’s high enough to pull timing back during WOT?

No it was able to do full pulls without pulling timing I guess faster recovery time I know fluid capacity plays a big part that’s my next step increasing that

 

[Cory S]

No it was able to do full pulls without pulling timing I guess faster recovery time I know fluid capacity plays a big part that’s my next step increasing that

Do you have fans in your heat exchanger? If so, I’d remove them. Also, the IC bricks are very minimal increase in cooling. You can only fit so much in the space provided. As long as your spark isn’t being pulled, and you have sufficient octane, you aren’t gaining much reducing post compressor IAT by a few degrees anyway.

 

[Scuba420]

Do you have fans in your heat exchanger? If so, I’d remove them. Also, the IC bricks are very minimal increase in cooling. You can only fit so much in the space provided. As long as your spark isn’t being pulled, and you have sufficient octane, you aren’t gaining much reducing post compressor IAT by a few degrees anyway.

I do have the fans

Sponsored