Inside rear quarter panel

[Performance nut]

Need to pull a dent out from my rear quarter panel. Problem is everyone is saying it won't come out because you can't get the back side of the dent due to the position. It is just above the rear wheel.

Is there something I can remove to allow you to access the inside of the rear quarter panel? If so, can it be removed and driven with it removed?

Sponsored

 

[aham23]

Just had one in the same spot fixed by the Paintless Dent Repair tech at my dealer. They got it 95% corrected without taking anything apart. I was told to get it 100% the have to dismantle "stuff." I am content with the fix.

 

[black1985gt]

I had my previous car repaired at a paintless dent repair shop as well and he got all the dents out. It cost $65 a panel but it was well worth it.

 

[AutoX_GT]

If it's the driver side you may be in luck, I don't think the rear quarter is blocked off underneath until above the fuel door. Just pull the fender liner..

 

[Performance nut]

If it's the driver side you may be in luck, I don't think the rear quarter is blocked off underneath until above the fuel door.

It is indeed the drivers side. How would you get to it?

 

[aham23]

A good paintless dent repair tech can get that out. All dealers have a guy who shows up a couple times a week pulling dents out of lot cars and customer cars. Ask them, or just look one up locally.

 

[MELLOWYELLOW06]

That should come out by an experienced dent removal tech.

One inch lower and it would have been a different story.

Sponsored