speedydave
Member
- Joined
- Aug 31, 2020
- Threads
- 2
- Messages
- 17
- Reaction score
- 12
- Location
- hickory, NC
- First Name
- Dave
- Vehicle(s)
- 2020 GT PP1 Oxford White
- Thread starter
- #1
I'm not sure where to post this, but I saw a video the other day and for priming the oil pressure on a Gt-350. Like if the car has been sitting for a while, or after an oil change. Anyway, I tried it on my GT and it worked.
My car is a 2020 manual, so your results may vary.
The video shows doing the normal start procedure, push clutch in and hit the start button, But in addition, hold the gas pedal all the way down too. Like push in the clutch and floor the gas pedal and hit the start button. The engine will crank for several seconds and build oil pressure, but not start.
After that you can start it like normal, but the engine has been primed.
Similar gt-350 discussion here: https://www.mustang6g.com/forums/threads/engine-priming-after-winter-storage.155323/
My car is a 2020 manual, so your results may vary.
The video shows doing the normal start procedure, push clutch in and hit the start button, But in addition, hold the gas pedal all the way down too. Like push in the clutch and floor the gas pedal and hit the start button. The engine will crank for several seconds and build oil pressure, but not start.
After that you can start it like normal, but the engine has been primed.
Similar gt-350 discussion here: https://www.mustang6g.com/forums/threads/engine-priming-after-winter-storage.155323/
Sponsored
Last edited: