Thanks, did not want to "gorilla" it in the event it had plastic fasteners.
I am old, the aluminum panels doesn't do anything for me and I don't like CF.
Not looking to do a wrap. Intent is to use walnut veneer, fill with shellac and finish with lacquer.
There are lots of clips in there to gorilla off, this isn't the full thing but should give you an idea. If you check the Sync 3 conversion thread you might be able to find the link to the replacement clips. There are some orange ones available on ebay for $12 for a set of like 100.
I have a set of cheap interior part removal tools on order from Alibaba, ...so whenever the slow boat arrives.There are lots of clips in there to gorilla off, this isn't the full thing but should give you an idea. If you check the Sync 3 conversion thread you might be able to find the link to the replacement clips. There are some orange ones available on ebay for $12 for a set of like 100.
Not sure how much use the trim tools will be. I have a decent set and they did nothing for me. Start on the far right and work your way left back to the wheel. While I didn’t break any of the tabs, 4 of the tab clips came off of which 3 were recovered. Might be handy if you could get the tab clips prior to the project. Good luck with your project. I’ve attached a few pics so you can see where the tabs are and where to apply steady pressure. I’m interested in seeing how this turns out.
