jchristena
Well-Known Member
- Joined
- Nov 18, 2015
- Threads
- 17
- Messages
- 113
- Reaction score
- 50
- Location
- Austin, TX
- Vehicle(s)
- 2015 GT
- Thread starter
- #16
Roh92cp has a good recipe.I'm about to do a similar project but was just going to run power to fuse panel somewhere though not sure where yet. Any suggestions?
1. Mount the fans.
2. Create a harness for the fans.
-8 gauge with inline fuse to a 30 amp relay from the +12v power block.
-Relay out with 8 gauge and split to 10 gauge for each +12v on the fans.
-Use the IC pump +12v as the trigger wire for the relay...so it comes on when the IC pump is on.
-8 gauge from ground to fans. Split to 10 gauge for each fan.
[MENTION=16819]Roh92cp[/MENTION] please correct me if I am wrong.
Sponsored