Scp-steve
Well-Known Member
- Thread starter
- #1
My shop cars up for sale
It's a gt with the performance package
Has 3600 miles on it and is in as new condition
The car is white with a black stripe
Has the following mods
Oil pump gears and timing gear
Nitto 305/35/19 rear tires
255 fronts
Eibach lowering springs
ARK performance grip exhaust
373 gearing
331 gears in box if wanted
Roush rear spoiler
Cervinis stalker hood
Roush phase two blower package
Ported heads flowing 351 cfm
Ported blower
Ported blower elbow
Ported t body
K2 palm beach dyno air filter
Reisch 170 t stat
Steeda clutch spring
Rst clutch
Aluminum flywheel
What it needs:
New stripe on the hood
Carbon fiber drive shaft
Upgraded rear axles
69mm blower pulley
This is what I would do to finish the car out^
The car was just retuned by peitz performance here in Houston
Made roughly 660-665 rwhp
It runs like it does too. The car is garage kept and hardly driven
I have cat deletes from mak o there way that will go into a second set of factory headers. This way the car will be set up to pass emissions
Testing simply by swapping the cat delete pipes back to catted pipes
I am asking 40k but will take 39k
Open for offers too
Steve frank
Owner of scp head porting services
It's a gt with the performance package
Has 3600 miles on it and is in as new condition
The car is white with a black stripe
Has the following mods
Oil pump gears and timing gear
Nitto 305/35/19 rear tires
255 fronts
Eibach lowering springs
ARK performance grip exhaust
373 gearing
331 gears in box if wanted
Roush rear spoiler
Cervinis stalker hood
Roush phase two blower package
Ported heads flowing 351 cfm
Ported blower
Ported blower elbow
Ported t body
K2 palm beach dyno air filter
Reisch 170 t stat
Steeda clutch spring
Rst clutch
Aluminum flywheel
What it needs:
New stripe on the hood
Carbon fiber drive shaft
Upgraded rear axles
69mm blower pulley
This is what I would do to finish the car out^
The car was just retuned by peitz performance here in Houston
Made roughly 660-665 rwhp
It runs like it does too. The car is garage kept and hardly driven
I have cat deletes from mak o there way that will go into a second set of factory headers. This way the car will be set up to pass emissions
Testing simply by swapping the cat delete pipes back to catted pipes
I am asking 40k but will take 39k
Open for offers too
Steve frank
Owner of scp head porting services
Sponsored