Any places that do a good job with S550 header installs? Have read the long tubes are a pain to install so I’d like a shop that does them on the regular
All,
New to the forum and I’m sure there are dozens of LTH install threads. Im looking to have this done and avoid the hassle of doing it on jackstands over a weekend. Anyone know of shops or mechanics in the Lancaster, Harrisburg or York Pennsylvania areas that would do the install? Im having...
So I got a used twin 69mm, had to buy the y harness.. then went to bolt it on and it seems that there is some modification needed so that it doesn't hit the coil cover.
2015 gt with a roush 2300. The circled part in the image is coming in contact with the coil cover.
So I recently installed the front and rear anti roll bars from Whiteline. I really don't think which brand you go for matters.
But the tutorials make it seem super easy. The gap between tutorial and reality is the biggest of any mod I have done to date. An absolute nightmare
Hey everyone, currently I have a set of texas speed 1-7/8 304 stainless steel long tube headers with an off-road connection pipe (catless) sitting in my garage. Tomorrow, 4/23, I will also be purchasing an 18-intake manifold (not ported) with imrc lockout, 18 stock air box (used off ebay), and...
Happy new year everyone!
I have a 2015 base model ecoboost (auto, non-pp) and a 6-piston GT PP brembo brake kit(rotor, lines, pads, caliper) + 2 piston regular GT's rear brake kit (13inch rotor, brake line, caliper, pads)
I am having some trouble figuring out where should I go to install them...
The wait is over. The Gen 5 3.0L Whipple finally get’s installed on our 2021 F150!
As always if you have any questions or concerns just reach out to us at 561-753-8105 or email [email protected].
The wait is over. The Gen 5 3.0L Whipple finally get’s installed on our 2021 F150!
As always if you have any questions or concerns just reach out to us at 561-753-8105 or email [email protected].
The wait is over. The Gen 5 3.0L Whipple finally get’s installed on our 2021 F150!
As always if you have any questions or concerns just reach out to us at 561-753-8105 or email [email protected].
Three weeks ago, I had the full front end and the black trunk panel of my 2021 Mustang wrapped in Xpel ppf. On the grill piece, there is a section that is not stuck down and now dirt is collecting under the film. There are also a couple other spots where there is dust or lint underneath the ppf...
I’m either weak af or this belt is damn near impossible to install. I have got it on once. But it wasn’t sitting on all the threads on the balancer. Also the tensioner was set at 95 instead of 100 like the manual recommends. I have the idler all the way down.
am I doing something wrong here...
Just bought headers and I know it’s a pain on jack stands but has anyone from Alabama, Mississippi, Tennessee, or Arkansas paid a shop to do it? Trying to figure out prices near me and if you reccomend someone.
I would rather do it myself but not having a lift close to me makes things difficult.
Hey guys. It’s been 15 years since having a set of lowering springs installed on a Mustang. Since recently purchasing a 2017 GT, I have acquired a set of BMR Performance lowering springs. I am located in southern Georgia, and I am wondering what the average going rate is for a shop to install a...
Has anyone tried installing a factory grille into a gt350 style bumper conversion? I want the gt350 style but I also want to keep the RTR grille. Could it be done?
Had a header leak, car was throwing po171 code (system to lean) bolts had fell out of the passenger side of my headers causing unmetered air to go in.
Got it fixed and everything retightened, car is still throwing same code but runs better, gas mileage went up immediately, sounds better and...
I have a new to me 2018 Ford Mustang Gt with the 9 speaker system without a subwoofer. The system is adequate, But I want to add more bass. Can I just buy a powered subwoofer, hook it up to rear speakers and call it a day? I keep reading all this stuff about Forscan and LC2i, Do I really need...
Does any know if there’s a way to install the ford pass connect modem to a 2015-17 mustang like the newer mustangs. I want to be able to remote start my car with my phone or have it turn on automatically at set times to heat up or cool down. I want to be able to track it, or have WiFi from the modem
Hi All,
I wanted to add a quick video of how I installed my Ngauge into my center dash vent. Don’t forget to subscribe for gift card giveaways and future videos!
<————-video of install!
Thanks
Hey All!
just wanted to show a couple how-to videos we have on our YouTube channel. We plan to keep adding more video, so make sure to subscribe to channel!!
. <——— the detailed install of how we did it!
Thanks
@MGW
Really need some help, please. I'm installing (or trying to install) my MGW race spec that I've had sitting in my garage since May. Everything went well enough until I got to the linkage bolt.
I cannot get the bolt that holds the shift linkage to come out. The bolt loosens, spins/rises...