MudFlaps/Mudspats

Just wondering if anyone has looked into buying and putting on moulded flaps/spats?
There are a few suppliers in the US that sell moulded sets that don't look too bad and they require no drilling. They seem to call to them Splash Guards or Rock Guards over in the US.

I bought some, arrived here Friday from RSI

http://www.rpidesigns.com/shop/item.aspx?itemid=5419

http://www.mustang6g.com/forums/showthread.php?t=41689&page=20

Hunter said:

http://www.rpidesigns.com/shop/item.aspx?itemid=5419

http://www.mustang6g.com/forums/showthread.php?t=41689&page=20

Click to expand...

Thanks Karl
American Muscle want in excess of $200 US for a set of 4 plus shipping costs and they are out of stock at the moment anyway.

Hunter said:

I bought some, arrived here Friday from RSI

Click to expand...

Karl, what's the quality like?

tarabrae said:

Karl, what's the quality like?

Click to expand...

Also wondering what the quality is like Karl and also how much they charged in shipping

subscribe

I think these are the ones that are being referred to:

Check out post 352 in this link:

http://www.mustang6g.com/forums/showthread.php?t=41689&page=20

Im making some that are integrated into winglets that are similar to the roush ones

RSPEC-015 said:

I think these are the ones that are being referred to:

Check out post 352 in this link:

http://www.mustang6g.com/forums/showthread.php?t=41689&page=20

Click to expand...

Yes these are the ones. Upon reading further about the product the front ones just clip in/on without removal of the wheels however the rear ones require you to remove the wheels as they require screwing in place.
Here is another mob in the US that make them however only for the front at this stage. They are working on a design for the rears. They call their product Rockguards. Still at cheaper alternative than what the set of four are from American Muscle.
https://www.zl1addons.com/index.php...ford-mustang-2015-16-front-rock-guards-detail

I just printed up these. What do you guys think?

prototype 1 - roush style/no flap

Prototype 2 - roush style/inset flap

Prototype 3 - roush style/vertical even flap

mate, I prefer the bottom ones. In black they wouldn't look out of place and they'll protect the body work better.

Hunter said:

mate, I prefer the bottom ones. In black they wouldn't look out of place and they'll protect the body work better.

Click to expand...

Oh. I forgot to say that the orange was just so the features would stand out in pics. I just used some of my scrap filament. Should the extend down further...out more?

How about this for those requesting wider? I went out .5" and down .5".

really good!