If you have a friend with a programmer , just change the code yourself or have them change it.4 modules on Ebay right now, all you gotta due is figure out if there from a premium!
Is this the only value in the BCMB that needs to be changed in a 2015 50Yrs A/P car to enable full support (incl MyColor) for the illuminated sill plates?If you have a friend with a programmer , just change the code yourself or have them change it.
Change 7B7-01-1 to 0042 0000 02
In the LE and 50Yrs Pkg it is 0040 0000 00
You can look it up on the motorcraft dot com web site in the as built area for module data.
The other values are the sameIs this the only value in the BCMB that needs to be changed in a 2015 50Yrs A/P car to enable full support (incl MyColor) for the illuminated sill plates?
Thanks,
MikeV
I have a set of illuminated sill plates waiting to be installed and I just ordered the programmer. Time permitting and providing I get the device and the software installed and running on Windows 10, I will give this a shot over the weekend and report back with the results.The other values are the same
I installed the illuminated sill plates into the stock harness connection and tried this today and it did not work. I have a 2105 convertible worth the 50yrs A/P and after setting 7B7-01-1 to 0040 0000 00 the convertible top stopped working. Changing it back restored the convertible top functionality bit it seems there is another setting needed for the convertible.If you have a friend with a programmer , just change the code yourself or have them change it.
Change 7B7-01-1 to 0042 0000 02
In the LE and 50Yrs Pkg it is 0040 0000 00
You can look it up on the motorcraft dot com web site in the as built area for module data.
I used this one:This is great news, I have some takeoffs coming next week, I have a fastback though, so hopefully the code MustangChief gave will work. What programmer did you use?
Pretty much that's it. The take-off sills that I bought were wired with a connector that plugs right into the factory harness. You would have to pull up the plastic trim piece between the sills and the seat to confirm your car has the necessary wiring in place. Then it's a tool-less install.Thanks for the info Nemesis! So all I need to install the illuminated sills in a 50th LE is the harness (included with the new sills) and the ScanTool OBDLink correct?