Search results

Finally got her in to a local shop today. Toe was way off. The car drives substantially better now.

*** Resolved, updated with alignment print off below*** I searched around on here for a bit and couldn't find anything that matched my situation. Just got my 2016 PP a couple weeks ago and it seems this car tramlines pretty bad. This is my third Mustang, first in four years and I can't...

In November of 2016, I purchased a 2017 base GT manual in Grabber Blue. After only five thousand miles, I traded it in as the car was just… missing something. I always missed that car though. Flash forward almost five years exactly to the day, and due to a trade in offer I couldn’t refuse, I...

The AC system has sensors in it to deactivate clutch engagement if refrigerant pressures are too low or too high to prevent damage to the compressor.

I believe I read somewhere else on this forum that on hot days, the ambient air temp reading wont update until the car has been driven for a bit as for the readout to not give an artificially high reading from heatsoak from the sun. Next time it gets stuck, maybe take it on a ten minute mini...

I'm 90% sure the port injection is mostly going to be to keep the intake valves clean and to avoid alot of the carbon problems found on direct injection only gasoline engines.

I would think if you measured the diameter of the port that needs to be blocked off and then showed a picture of that rubber cap at an auto parts store they would be able to find something similar if not the same cap for you pretty quickly. If not AutoZone/O'Reilly's I would try Napa.

You're very welcome!

Go in the Driver Information Center (screen between your speedo and tach). Go to settings > vehicle > locks > remote unlock > make sure 'all doors' is selected. Maybe that's it?

I can see the pictures now. Wow what a difference! I'll be taking care of that before I head out of town for a long weekend. Thanks for all the help!

I can't see the pictures on my phone so I'll have to glance at them on my PC later. What did you find to be the easiest way to gain access to the adjustment screws?

Do you happen to remember if it's just a Phillips screwdriver for the adjustment, or if it's a hex/torx? And did you do your adjustments with the lights shining on a wall or the lights pointed down the road?

Exactly the info I was looking for! I knew about the adjustment for the headlights but didn't wanna start taking stuff apart for a fog light adjustment if there wasn't one. Thanks! The headlights arent too bad on mine but I may try a half turn of adjustment and see what that does for them.

I understand the purpose/use of fog lights lol, and I'm not trying to raise them to a headlight level, I would just like them raised enough so that they're beneficial in poor visibility conditions. Right now they only really illuminate the front 3 or so feet of the ground directly in front of...

I was wondering if there is an adjustment for the vertical aim on the fog lights? To me they seem pointed waaay too low. I often drive some roads with very old striping that has lost all of its reflectiveness and is nearly impossible to see in the dark when it rains, or let alone be foggy. When...

I guess I'm just paranoid lol. My '06 GT started doing the same thing at around 110k miles and when I pulled the cats off for exhaust work the cats had started to melt themselves inside.

I have a '17 GT that is 100% stock. When I drive anything less than about 45 minutes, when I back into my driveway I can smell the awful smell of bad eggs and sulfur. Enough to make me scrunch my nose up sometimes lol. I hop out of the car and even getting my nose just near the exhaust tips the...