Paxton 2200sl 3.6 pulley
JLT intake
Id1000s/bap
Billet OPG/ lower CS
Full exhaust
Tuned by Rob Shoemaker
First two pulls are on 93 octane. Last pull they put a full bottle of VP octanium in. I gained 48 RWHP!
684/546 on VP octanium SAE Smoothing 5
*Ignore the A/F on the dyno sheet, their...
So right now my current setup is a Paxton 3.80 on 93 octane (id100s) with a vortech bap. I made 610 504. In march i'm getting opgs/cs done. At the same time I was thinking about having the 3.6 pulley put on and e85. My question is without a fuel system can I even run e85? Or If I wanted to max...
Today I decided to hook my Nguage up just to monitor a few things (no longer tuned by lund)
I have a paxton 3.80 stock bov, bap, full exhaust...
1 and 2nd gear winding out the gears knock is 0.00 to -4.xx which is normal.. But when i shift into third I have seen up to +3.00 degrees of...
My idle is set to around 750 which imo is normal. After driving and rolling to a stop in neutral my car will idle around 1000-1200 and then fall back down after sometime.. Is this a big deal? Should I contact my tuner? It just started doing this (temps fell below freezing last two days).. Here...
So several months ago I had new tires put on.. I have a slow leak in my front tire. When a shop tried to remove it my key snapped in half they happened to have another just like it but that one started to bend, Apparently my lugs were overtightened. They are inner spline (female)..
What are...
id1000s, cold spark plugs, paxton 2200sl
When the car sits for several hours and I go to start it after a long period of time it struggles to run for about 1min then it idles fine. Listen to the videos below. With Lund the car would rev way up and hold it for about 30 seconds then come back...
Boosted setup with id1000s, bap, 93 octane.
idle-
wot-
Also what rpm do you idle at? reason I ask, my new tuner has my car idle around 600 and it seems a bit low compared to what Lund had it idle at.
A week from today a buddy and I will be installing my Paxton 2200sl kit. My goal is to break 600hp. The tuning will be done at a local shop. Here is all my mods:
2015 Mustang 5.0
Manual transmission
3.55 gears
SP Longtube headers w/ High flow cats
Ford racing X pipe
Roush Axle Backs
Paxton...
I got the beefcake special and I'm doing the install with a buddy in a week, been reading over the instructions and with the bypass valve there is a step to recirculate the air back into the intake tube as a stock kit is designed.. my question is what if I don't and just leave it open ( I would...
I ordered the beefcake special and got the maxflow bap. There were no instructions included and I cant find anything online for the 2015.. Anybody have a link or can give me some detailed instructions. I believe i have the non programmable.. If I were to order this over I would have went with...