Search results

OK so I found the Evaporator drain holes, There is one on each side of the transmission tunnel they both are the same a black Grommet with a hole. They are Just rearward of the catalytic converters. on each Side of the Tranny. I took pics with my phone but they dont show much... I leak...

Anyone know where they are specifically? Maybe ever pictures to help with locations? I understand there may be two of them TIA!

I will write more later, but it ended up being my resistor harnesses for my LED switch backs, both went bad at the same time!! Ugh

My inner parking/blinkers blink fine is there a fuse or something for the Parking lights? They both do not light when switch is placed in park... TIA

So after almost three years, Im having difficulties with my LED resistor harnesses.... I had one side that was not connecting well, the other side was fine, so I dismantled the harness connections an now both Inner Parking lights do not light, so Im wondering why? Also I found that I cannot put...

Anyone have either? Shipped to Florida. Please PM me to Discuss. Thank you in advance! :thumbsup:

Ive done that before, Sometimes that white is paint from rub. may not be through to the primer. I rub my pickup all the time against the garage weather strip which is white it looks like that.. I hate to say it but I use Carb cleaner to get the white paint off...lol Then rebuff and wax...

57 GT PP MT :thumbsup:

Well arent you just full of yourself.... I agree with you that he should certainly find someone he trusts... But until then there is nothing wrong with putting it into a CD. He will at least have positive gains and no risk.. Cash is always king, investing is always risky... No...

Put it initially in a very low risk fund and then over time if you want to take more risk you can transfer into higher risk funds... they all will offer similar products Schwab Fidelity. You may also consider Ally Bank and put it into a IRA CD, CD's are insured where mutual funds are not...

If you decide you want to ship the New one PM me. I need one to complete a set..Thank you! GLWS!

Loosen all your connections and jack up the rear of the H Pipe (put a towel or something soft over the jacking point), then tighten. You may have to rotate the rear sections to get them into place. This helped me keep the tips up high in the valence and haven't moved since. 1.5 years 16,000...

I have had mine Street Stainless on for 1.5 years and 16,000 Miles rasp lessens over time totally different sound then when new.... When Installing mine I used a floor jack to raise the rear of the H pipe (per a suggestion by a forum Member here), Tightened up the connections...They are tight...

I think Normal, part of Start-up trying to get the Cats Hot... :thumbsup:

I love my Airaid Tube GLWS!!! :thumbsup:

Im not sure about your nuts....lol But the torque on those is usually pretty low like 28 ft/lbs. Dont over tighten. :thumbsup:

Tell him I'll ship it USPS, he may never see it again... :D

Installed my Anarchy Motive custom made shift knob.... :headbang:

Installed... :headbang:

Well here are a couple pictures of my Batman themed knob. It really is a piece of craftsmanship. Derrick followed my directions to the letter when I described what I wanted. Pictures don't do it justice shows a little darker in person, which is what I wanted. Derrick had some shipping...