And just to be clear, I have a 2016 "Base" Performance Pack Ecoboost Mustang. I installed the Premium radio bezel which has the additional 4th switch, "Drive Mode." The switch did not work until I modified the As Built Information. The key is to find a vehicle that is the same year and has...
The IPC starts with block 720-XXX-XXX and the ABS system starts with block 760-XXX-XXX.
In order to activate drive modes on a base model you need to change the IPC code to display the drive modes menus on your cluster as well as change the ABS system codes to activate the drive modes...
I wasn't able to get any A/C controls. I'm assuming that information is on the MS CAN lines which may be vehicle specific codes and not shared by other platforms.
Just a heads up for anyone using a modified premium bezel with an aftermarket radio. You can get steering controls to work using a PAC SWI-CP2, use programming and installation diagram from a 2016 F150. It's real easy to install and it been working perfect for over a month. Link below...
Just a heads up, I purchased a spare base bezel on ebay hoping I could modify it as well but I ended up returning it because the would need to cut the circuit board. It seemed like most of the circuits ran in series so if cut the board there is a risk you could damage the entire board. You may...
I replied with this earlier. I guess no one reads long boring thread post lol. Not saying it's 100% true but.....
I used a Maestro RR on my install and attempted to keep the sync module installed into the car in order to keep my steering wheel controls and sync system. I loaded multiple...
I don't know if the FCIM will not work on premiums if the sync module or APIM is removed. What I do know is you will loose certain Heating and A/C control features when swapping the premium bezel into a base model. On my swap, I cannot select floor vent controls or easily switch between...
First, I apologized for the long write up, I haven't been on the forum recently due to school so I've got a lot to say. I installed a Kenwood Excelon DDX 9903s and used the premium bezel to do the install. In order to get the faceplate flush with the bezel, I had to cut the plastic enclosure...
Did one in my car... i got ecu data and tpms monitoring working using a maestro rr programmed off a 2015 F150.
I have not gotten steering wheel controls or climate controls to work on the stereo yet. I'm gonna try and find out what the CANBUS codes are for the steering wheels and climate...
You can program the maestro RR to work without the sync system. I've done it in several Fords. The you can program the maestro RR to not incorporate the sync system but I believe in order to get the steering wheel controls to work with the maestro RR you will need the to have the sync module...
Try changing out the batteries in your remotes..... i know on some aftermarket alarms the keyfob or alarm siren does extra chirps letting you know your keyfob batteries are low
It's nice to see good work. What sound deadening material/company are you using. I like the all black. I'm only experienced with Dynamat but want to try something not as messy.
Thanks,
I almost found one in OC on Craigslist but the guy was all over the place so I scratched that because of the drive. I think I'll be going to the junk yard this weekend. Maybe I'll get lucky.
I definitely want to get some drive time in. It'd be nice to go on a cruise.
Question for everyone, I finally got my ecoboost about a month ago. Does anyone have or know where I can get a base or premium radio bezel? Preferably the base bezel but the premium will work too. I'm looking to make and aftermarket radio kit and need a spare radio bezel to test with...