Sponsored
from your excess steel plate cut 2 triangular braces and weld them in. now grind both sides smooth.
once complete it should look like this
take you angled steel and evenly hammer it from 90 degrees to 45 degrees. it must be even. find the center of your angled steel and the center of your
take your lic plate and vanity trim if that's your preference, place them over your bracket with a marker, mark your holes. remove the plate. with a h
from your excess steel plate cut 2 triangular braces and weld them in. now grind both sides smooth.
on a flat surface weld both sides of all plates then grind them smooth.
cut the bottom of the bracket at a measure of 8". then cut the sides at 5" each.
once you have the distances marked, transfer them to the flat steel bar. the bar should measure approx. 13". the distances of the holes when placed on
REDHRSE

from your excess steel plate cut 2 triangular braces and weld them in. now grind both sides smooth.

There are no comments to display.

Media information

Album
RedHorse custom license plate holder (no body mdifications)
Added by
REDHRSE
Date added
View count
209
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
SAMSUNG SM-N900P
Aperture
Ć’/2.2
Focal length
4.1 mm
Exposure time
1/24
ISO
50
Filename
860-1423345720-411a87e09634d2b68b853a5f5d732f00.jpg
File size
80.9 KB
Date taken
Sat, 07 February 2015 11:21 AM
Dimensions
448px x 252px

Share this media



Top