black bart
Active Member
- Thread starter
- #1
A few weeks ago I found a new Hyundai Equus 19" spare with the full jack accessory kit unused on Ebay. I needed to buy two Lenox hole saws, 2 5/8 and 2 3/4 and an arbor. Mounted both hole saws on the ardor and cut half way through from both sides. The 2 5/8 was a perfect guide for the old Hyundai center bore. Bought some 9/16 id - 1 3/8 od washers and a five m14x1.5 hex bolts. Mounted the spare on both the front and rear today without any problems fitting. I don't have the Brembo front calipers just the standard GT Premium calipers. The entire kits and spare fit in the trunk tire well tightly. I used the oem screw down on the wheel and it fits like it was made for it. No bulge of the spare cover. Had a long long wait for one of these Equus 19" spares to pop up but seems to be much cheaper than the alternative $568.00 spare kit currently offered by an aftermarket outfit. I also looked at an oem used 20" Foundry wheel and tire combo but couldn't find one that wasn't beat up. Don't have pictures but I'll answer any questions that people have. BTW I did read the post regarding another Mustang owner who did this a year or so ago. Really very easy job.
Sponsored