What did you do to your S550 Mustang today?!

[Briebee72]

took all my mods off and returned her to factory in prep for selling....

Sponsored

 

[Briebee72]

Blasphemy.

Ha, wont no one here miss me anyway LOL :( Poor old mustang dont get no love since i bought the supra. I loved the stang but honestly the supra is a much much more fun car to drive. poor stang just collecting dust. but we gonna sell her and get another supra LOL for the little woman. then ill sit and wait for the s650... I may be back.

 

[ice445]

Washed it and drove it. 55 degrees and sunny today. Was nice to get that chalk off my car, it was drenched in it. We had a weird phenomemon where a storm picked a bunch of dirt and chalk dust from the western desert and it condensed with snow and covered everything. Once it melted, it made everything filthy lol

 

[Matti777]

Finished the installation of a BMR CB005 cradle bushing lockout kit. Next weekend I will install the BMR camber bolts and install new wheels and tires!

 

[shogun32]

5 inches of packed wet snow. Lol

did you try airing down your tires to like 18 psi?

 

[RonsterGT]

Mounted some new wheels and tires! I went with a set of MRR M600s in 19x10 +35mm in front and 19x11 +50mm in rear. Wrapped them in 285/35/19 and 305/30/19. Car is lowered on BMR SP080 springs (non-magneride). I ordered some black wheel caps with the Ford logo to put on them, I think it looks better than the plain black caps that came with the wheels.

Your setup looks sick! Wow. Perfectly flush, no poke by the looks of it.
What kind of drop are you running?
I ask because I’m waiting for my project6gr SEVENS, same specs, with same rubber - and I’m trying to envision the look - I’m running the Ford Performance street springs, dropped about 1”-1.25”

 

[Jennings1066]

I just drove my mustang. Love the basics

 

[BlackStallion18]

Your setup looks sick! Wow. Perfectly flush, no poke by the looks of it.
What kind of drop are you running?
I ask because I’m waiting for my project6gr SEVENS, same specs, with same rubber - and I’m trying to envision the look - I’m running the Ford Performance street springs, dropped about 1”-1.25”

The drop is 1.2 inches in front and 1 inch in rear, so your fitment should be similar. The drop isn't so dramatic from this angle, but is still good.

 

[Outlawtorn]

Took my brand new GT350 Steering wheel to the auto trimmer and hes going to strip it back, and the top and bottom will be trimmed in leather, the sides will be perforated leather (to match the GT seats) and the current leather stripe will be swapped to alcantara. I personally thought the alcantara trim on the 350 wheel made it look cheap? And my GT has no alcantara otherwise so at least the leather fits in with the existing trim. Will post a pict once I get it back.

 

[cactus_kid]

Took the Enkei wheels off.

 

[CJJon]

Bedded the new Brembo 6 piston brakes.

 

[Virnman]

My buddy installed 2 JL Audio 10’s for me. Big upgrade.

 

[Sins550]

Recently painted my brakes. Trying to break up this too much black thing lol.

 

[frank s]

Dummied up the reflective orange vinyl stripes on the trunk lid. They are six inches wide separated by a one-and-a-half-inch reflective black stripe that shows bright white in from-your-direction light, with a bare stripe five-eighths-inch between the black and orange vinyl. Treatment looks better than I expected, and isn't all that overwhelming where it is. The black seems dark gray in ambient light. The orange stays pretty much the same color, however it is lighted.

Next question: will transposing that pattern to the engine hood be too much? I've laid a bit of the black and one 6-inch stripe on the front, and decided adding an orange 5/8-inch stripe outside it improves the look.

Sponsored