What did you do to your S550 Mustang today?!

[Weasel1]

Mounted up my nGauge using a spare AC vent. Cut it up into a pod and clipped right in.

Pretty slick install. Well done sir.

Sponsored

 

[Dudie7]

Bought a new gun to keep in her.

 

[NoVaGT]

Bought a new gun to keep in her.

Don't leave it in the car 24/7 please. Or mount a safe. Don't let it get stolen.

What kind of gun?

 

[Rock&Roll]

Finally bought a exhaust for her. Hope I like it

 

[ForYourOwnGood]

Welp... I set up an appointment to fix my blue booty

 

[HISSMAN]

Now that I have built out my custom exhaust system with straight pipes behind the cats with an H pipe, and mid mounted race bullets just behind the crossover... I am going to go just behind those and build out a side exit system. I am addicted to welding right now.

 

[Joe B.]

Did the trailer hitch wiring harness. I'm not a fan of running any power wire under the car. In this case it's necessary to have a fused hot lead to battery. But I'm also satisfied that there is no more danger of damage to the cable than if it was run inside the cabin.

 

[Blue Moon]

My passenger side rocker panel stripe has been a little crooked for about a year, so I finally decided to strip it off and do it over. Now it's less crooked.

Then I put stripes on my trunk lid. For some reason it was harder to work with those curves than the ones on the hood. There are a few little wrinkles and they're just a little crooked. Good enough for now, but I'll probably redo them eventually.

And I put a tribar pony on each front fender. Those are straight. Small victories!

 

[randy_tho]

Did it fit right in the factory holes?
Edit. Looks like it will bolt right up where factory spoiler is.

MMD FOOSE, painted

 

[jri4]

Drove it to work for the first time. Also posted about it on this forum for the first time. Just picked it up last Friday...Hey everyone!

 

[Labradog]

Noticed that the outside edge of my front rotors is shiny. Smooth to the touch from out to in and no vibration under breaking. Is this an issue?

 

[GT Pony]

Noticed that the outside edge of my front rotors is shiny. Smooth to the touch from out to in and no vibration under breaking. Is this an issue?

Looks like the brakes are still "bedding in".

 

[JOKER M1]

Did it fit right in the factory holes?
Edit. Looks like it will bolt right up where factory spoiler is.

Yes, bolts up no problems at all. I only used the foam cushions supplied around the fastener holes and I didn’t use any 3M tape to assist in mounting the spoiler

 

[MacSrc]

Mounted up my nGauge using a spare AC vent. Cut it up into a pod and clipped right in.

How’d you do this?!

 

[khannected]

Just posted my car in classifieds section. Never thought I'd be getting rid of the car but need to fund the next stage of my life. Cleaned it up for some nice Fall time drives.

more info if you're interested

Sponsored