I’m going to see how I mind going back-and-forth from street to track these will be dedicated for the track initially.Nice list. I’ve been eyeing those steeda brake rotors for a while but haven’t popped on them yet. Still considering a couple other manufacturers.
Beautiful car and photo!
that is clearly a chip of some kind vs a paint flaw.Was in the garage noticed the car looked dusty decided to wipe it down and found this on the edge of the trunk! As you can see it is on the top and edge of the trunk. Don’t think it could have been a stone because of where it’s located and the fact that there is nothing on the rear panel side. Also the trunk sits lower then the panel. Anyone have any paint problems in this area?
Unless the paint hasn't adhered due to bad prep or some under paint contamination etc.that is clearly a chip of some kind vs a paint flaw.
Looks like they only have clear radiator plates in stock. Was yours black or clear.Got it from a website called Design Lab. I also got the Radiator Plate. They were actually a Christmas present!
https://designlab304.com/products/laser-engraved-acrylic-coin-tray
Yes, note the pressure goes up to 150 psl. Easy to use points to purchase the gauges and mats thru FairwayFordParts.net. Fast shipping too.I really like the oil temp gauge!
I have the black oneLooks like they only have clear radiator plates in stock. Was yours black or clear.
That sounds awesome!Got the GT500 Borla Atak put on
What oil separator do I want? Driver side/passenger side both/ C+L/J+L/Ford lots of choices? Also how do I install the faux driving lights decal to get the red pin stripe only?All weather floor mats, door sill decals, faux fog light decals, Redline hood struts, spare tire kit. Tomorrow, center gauge cluster with oil temp. Anyone share how to cut out the faux decals to leave out the center section. Also how to install the "Powered by Ford" engine decals?
J&L passenger side was what I went with.What oil separator do I want? Driver side/passenger side both/ C+L/J+L/Ford lots of choices? Also how do I install the faux driving lights decal to get the red pin stripe only?