65straight6
Well-Known Member
You know what they say… “One man‘s orange is another man’s red”Might want to check the color settings on your monitor/phone as that's Grey and Orange.
Sponsored
You know what they say… “One man‘s orange is another man’s red”Might want to check the color settings on your monitor/phone as that's Grey and Orange.
Slowly getting there. Turbos coming soon.
Did you install the MMR cylinder head cooling mods yourself?
Can this be done from the bottom if the transmission is removed?
Thanks
Jack
Did you install the MMR cylinder head cooling mods yourself?
Can this be done from the bottom if the transmission is removed?
Thanks
Jack
Yes. Also installed AR oil balancing linesDid you install the MMR cylinder head cooling mods yourself?
Can this be done from the bottom if the transmission is removed?
Thanks
Jack
1/13 Hahaaa, I electrocuted one of those who violated my baby....Just for grins (I really wanted to look at her), I removed the care cover and did a visual inspection. Popped the hood also and was then shocked at what I found….
Those little f%ckers, this is WAR. Got me some new electrocution traps and sticky pads.....Going to see how they like it....
You got lucky. Over Christmas those little bastards did $19K worth of damage to my wife's Cayenne, fortunately covered by insurance.Just for grins (I really wanted to look at her), I removed the care cover and did a visual inspection. Popped the hood also and was then shocked at what I found….
Those little f%ckers, this is WAR. Got me some new electrocution traps and sticky pads.....Going to see how they like it....
You may still have to loosen the mount nuts and tip the motor forward a bit, but that can be done if the trans is removed. Without creating additional space between the firewall and the heads, there's just no room to get any leverage or swing on a tool and getting the plugs out can range from fairly easy to difficult and even if you freeze the new fitting, you probably still have to tap them with a rubber mallet to get them to seat. I wouldn't have been able to just push them all the way seated with my bare hand squeezed between the firewall and the motor.Did you install the MMR cylinder head cooling mods yourself?
Can this be done from the bottom if the transmission is removed?
Thanks
Jack
130? Not in Virginia I hope...Quick run up to 130 for a bit to get woken up and get lunch after sitting two weeks and a snowstorm on the way. After oil warmed up of course. Then back into the garage.