The Sweet, Sweet Sounds of the Steeda H-Pipe (Video Inside)

[tj@steeda]

Hello All:

Our Steeda Team wanted to share the latest video on our very popular Steeda H-Pipe

Check out the different exhaust modes as the Steeda H-Pipe amplifies the already impressive active exhaust.

Enjoy!



TJ

Sponsored

 

[KP’s GT/CS]

Very happy with mine in combination with my factory active exhaust.

 

[TexasMetallic5.0]

Mine sounds good. I’m almost afraid to change up the exhaust because it sounds almost perfect to me now.

 

[tj@steeda]

I have the active exhaust & an H-pipe waiting for me from Christmas - this video just got me excited - until I look out the window & I see snow :(

Soon!

 

[Geosh]

Just installed my new Steeda H pipe on my active mufflers today. Sounds fantastic (not sure the wife likes all the extra volume, but that is what quiet mode is for).

Fitment was absolutely perfect. Very well built and fit up great. I used some heavier duty clamps though as The ones that come with it are just ok.

 

[scober]

I have one waiting for install when the car is out of storage.
Are any of you guys having issues with clamps loosening up, or has anyone had it welded on one end?

 

[Geosh]

I have one waiting for install when the car is out of storage.
Are any of you guys having issues with clamps loosening up, or has anyone had it welded on one end?

I read lots of comments about the clamps loosening and that’s why I went with heavier duty ones. Might just be initial stretching and settling though. If they start to have issues I’ll just get a shop to weld it.

 

[Chef jpd]

Get them welded and never worry about it again.
$45 at a local muffler shop for me.

 

[quikcolin]

I have one waiting for install when the car is out of storage.
Are any of you guys having issues with clamps loosening up, or has anyone had it welded on one end?

you and me both. April can’t come soon enough

 

[quikcolin]

Any exhaust leaks for you guys? I have my Steeda H pipe in the basement waiting for spring. Can’t wait to install

 

[FrankieFigs]

Any exhaust leaks for you guys? I have my Steeda H pipe in the basement waiting for spring. Can’t wait to install

I had a Steeda X pipe on my car for a while and I didn't have any leaks. Just make sure the included clamps are tight and stay tight. They do seem to stretch a little and loosen up or something. I had to readjust my axle-back sections and retighten the clamps a couple of times. After that, they stayed tight.

 

[quikcolin]

I had a Steeda X pipe on my car for a while and I didn't have any leaks. Just make sure the included clamps are tight and stay tight. They do seem to stretch a little and loosen up or something. I had to readjust my axle-back sections and retighten the clamps a couple of times. After that, they stayed tight.

Good advice. Thx for that! I'll check on the clamps after 1000km or so and retighten if needed

 

[Fordohio]

When we used a torque wrench to tightened the rear clamps to the recommended torque. I was surprised how much more it needed tightened from what I thought was tight.

 

[quikcolin]

When we used a torque wrench to tightened the rear clamps to the recommended torque. I was surprised how much more it needed tightened from what I thought was tight.

So you had to tighten it more than the recommended torque?

 

[Fordohio]

So you had to tighten it more than the recommended torque?

No I tightened them with my electric impact to what I thought was tight. Then we used to torque wrench to check. It tightened down quite a bit more.

Sponsored