FBO5.0
Well-Known Member
- Thread starter
- #1
So I bought an Ace twin disk clutch (part number RSK-300M) for my 2015 Mustang GT, and the OEM throw out bearing is too long for the kit to fit. I called ACE and was told I needed to get throw out bearing part number DR3Z-7A508-A which is used on GT500's from 2010-2014. Apparently it is shorter, but I'm concerned because the input shafts on the S550 GT is 1/8 of an inch smaller and there's not one site out there claiming this part fits in my car. I can't find anyone else that has had this issue and I'm kinda ticked that ACE doesn't mention the need for this part as I bought a new OEM throw out bearing for the installation. I went with ACE because Shelby American sells them for their Shelby GT, which has similar power to what I have. My car basically has a stage 2 Roush supercharger kit on it tuned by Lund.
Can anyone help me?
Can anyone help me?
Sponsored