Infamous
President of Honda
- Thread starter
- #1
Another Steeda addition to my Mustang!
I was always concerned with my vehicle's chassis bending whenever I lifted it, even when I used the factory lift points. Now with the introduction of the jacking rails that monkey is off my back.
My first impression of the rails was that they were of strong quality, with a black powder coat finish. The rails themselves are lightweight, and durable as they are made of steel.
The installation instructions were very straightforward, allowing me to have the rails on the car in as little as 15-20 minutes.
This is what the jacking rails look like on the vehicle:
The only downside about the whole installation was not being able to use the jacking rails.
If you need to lift your car for X reasons, then these jacking rails are a must.
You can't go wrong with Steeda :cheers:
I was always concerned with my vehicle's chassis bending whenever I lifted it, even when I used the factory lift points. Now with the introduction of the jacking rails that monkey is off my back.
My first impression of the rails was that they were of strong quality, with a black powder coat finish. The rails themselves are lightweight, and durable as they are made of steel.
The installation instructions were very straightforward, allowing me to have the rails on the car in as little as 15-20 minutes.
This is what the jacking rails look like on the vehicle:
The only downside about the whole installation was not being able to use the jacking rails.
If you need to lift your car for X reasons, then these jacking rails are a must.
You can't go wrong with Steeda :cheers:
Sponsored