DaveH
Well-Known Member
- Thread starter
- #1
This is just an FYI post for you all. I ordered a lovely custom titanium shift knob from Lathewerks and unfortunately the normal thread pattern from the GT doesn't fit.
I've since measured it, and have now seen that it is M10 x 1.25 instead of the usual M12 x 1.25.
Hopefully this saves anyone else from making a mistake like I did!
I've since measured it, and have now seen that it is M10 x 1.25 instead of the usual M12 x 1.25.
Hopefully this saves anyone else from making a mistake like I did!
Sponsored