Replaced factory CV axels on my 2018 ford mustang Eco

[Jarronkirk123]

So I ordered some CV axles on Rock Auto because I was trying to save some money; I purchased the customer-recommended part (which was supposed to be a direct OEM replacement). I made sure each axle went to the correct side and that everything was seated and all bolts were torqued. I ran into an issue when I got to the end of the installation, when I tried to put the ABS sensor back in the knuckle; it didn’t fit because there was a lip blocking a portion of the hole. I went back and made sure everything was tightened up, but I couldn’t figure out why I couldn’t fit my sensor back in place. Anyone got any ideas?

Sponsored

 

[sox3]

Pics would be helpful