New PB in good air today. Street SS’s doing some work.

[Cory S]

700DA.
Loaded it up to 1500rpm on the foot brake. She ate some dinner.
Stock driveshaft and just proper rear camber.
VMP Gen3R/Twin Jet 69mm
305/45/17 M/T Street SS @ 17psi cold.
E78
2.80” (72mm) 6-rib Griptech pulley (17psi) stock damper.
3.15 gear (3.55 going in this winter).
PP 5W-30

Sponsored

 

[Proshop]

Nice time and wrinkle!

 

[ypena02]

Nice! Anything done to the engine/trans?

 

[Cory S]

Nice! Anything done to the engine/trans?

Pistons/rods/studs. PBH built 6R80.

 

[Cory S]

Mods, can we move this to the Dragstrip and launching forum please. TY.

 

[Andy13186]

Nice run.

 

[Whitedevil95]

Pistons/rods/studs. PBH built 6R80.

Thats an amazing 60ft for a tire that is very streetable. Does the converter make a huge difference in the launch?

 

[LS1Coupe]

Doing work in the first 60 feet!

 

[Cory S]

Thats an amazing 60ft for a tire that is very streetable. Does the converter make a huge difference in the launch?

Never had it at the strip without it. Flashes at 3100 off the brake, so I would assume it was good for a 10th or 2 drop off the line.

 

[Stage_3]

Very nice man. Moving out.
Congrats!

 

[HKusp]

Super nice!!!

 

[beefcake]

nice!

 

[Kennysum1]

Stock suspension?

 

[Cory S]

Stock suspension?

Basically yes. Camber arms for proper camber, BMR drag springs, and subframe alignment dowels.

 

[Kennysum1]

Any idea what you are putting down? 850ish hp?

Sponsored