turbofiveoh
Well-Known Member
- Thread starter
- #1
Since Whipple is closed for the holiday I was hoping somebody here might be abke to help me.
My flare tool decided to quit working and whipple was kind enough to send me a replacement. When I plug in the replacement and try to open my flare calibration file I get an error in the software. The error reads “bad gateway” followed by an ID and some numbers.
Has anybody here had a similar issue and if so how did you fix it?
I suspect it is an issue that whipple needs to address but if I’m doing something wrong it’d be good to fix it now and not waste anybody’s time at whipple.
Thanks for any help.
My flare tool decided to quit working and whipple was kind enough to send me a replacement. When I plug in the replacement and try to open my flare calibration file I get an error in the software. The error reads “bad gateway” followed by an ID and some numbers.
Has anybody here had a similar issue and if so how did you fix it?
I suspect it is an issue that whipple needs to address but if I’m doing something wrong it’d be good to fix it now and not waste anybody’s time at whipple.
Thanks for any help.
Sponsored
