melwff
Well-Known Member
- Joined
- Oct 4, 2016
- Threads
- 6
- Messages
- 884
- Reaction score
- 299
- Location
- Danbury,CT
- Vehicle(s)
- 2021 Mach 1 M2486
Should start KR3Z and end with AAFYI, those part numbers bring up the adjustable strut mounts.
Sponsored
Should start KR3Z and end with AAFYI, those part numbers bring up the adjustable strut mounts.
Hey melwff,I just completed installation of the rears on my non-HP Mach 1. Took about 20 minutes per side. Jacked up one side of the rear to get additional clearance. Popped the three plastic retainers that hold the wheel well liner and moved it out of the way. Removed two existing screws that hold side of bumper. Installed two screw clips into existing holes, located molding pin into existing hole, replaced original screws plus two new ones, replaced liner into original position, reinstalled original three plastic retainers plus one new one. Only tools used were small screwdriver and 1/4" ratchet with short extension and socket.
They do not come with hardware.Hey melwff,
Did you buy the hardware separately? Looks like I can get the left and right rear for Taska for $106 but not sure if hardware is included.
any idea what the part # is for hardware?They do not come with hardware.
It's all listed here:any idea what the part # is for hardware?
I had a feeling that would be your follow up question.any idea what the part # is for hardware?
One more stupid question, do I need 2 of each of those hardware part #'s for both sides?I had a feeling that would be your follow up question.
W716195-S450B screw for 4
W714205-S307 nut for 4
W714040-S300 pin for 2
No that covers both sides, you saw the quantity I listed for each?One more stupid question, do I need 2 of each of those hardware part #'s for both sides?
Yes, got it... sorry, its a Friday...lolNo that covers both sides, you saw the quantity I listed for each?
Also, the splash guards in the spread sheet are the GT500 ones which are different from the ones melwff is showingIt's all listed here:
https://www.mustang6g.com/forums/threads/mach1-parts-spreadsheet.165838/
Look on Mach 1 tab in the spreadsheet and clips and screws below Rear Splash Guard Shield in the left column.
It is 716, took it directly from the invoice and the link in this thread for Levittown also shows 716.Also looks like the spreadsheet show part # for the screws starts with 715 and your screw shows 716
Yes, got it... sorry, its a Friday...lol
Where in this thread did I show the full number?Also, the splash guards in the spread sheet are the GT500 ones which are different from the ones melwff is showing