Jimmy
Well-Known Member
- Thread starter
- #1
I got a 2019 Mustang GT base/pp1 that's practically brand new with just over 3000 kms on it. Yesterday I was driving when a wrench appeared on the screen. I turned the car off then on again and the wrench was gone and hasn't appeared since, but now my backup camera, my hill start assist, and my rev matching all don't work. When I turn on the car it says "hill start assist not available" and when I put it in reverse it says "backup camera not available". For the revmatching it doesn't display any error message but it doesn't work. I have tried unchecking and rechecking the revmatching option in the menu and it doesn't make a difference. I hooked up an odb2 reader and it doesn't display any error codes.
I have called the Ford dealer and scheduled an appointment in a few days, but in the meantime I was hoping someone here might have some ideas. The car is completely stock and I can't think of anything I have done that might have triggered these problems, I was just driving normally and suddenly the wrench appeared.
I have called the Ford dealer and scheduled an appointment in a few days, but in the meantime I was hoping someone here might have some ideas. The car is completely stock and I can't think of anything I have done that might have triggered these problems, I was just driving normally and suddenly the wrench appeared.
Sponsored