Installing Sai Li fuel kit with rails (18+ gt). Got a couple questions

[Kona 18]

That will work too, the only thing is im not sure if the stock feed line will reach that spot on the front drive sider, even with the nitrous adapter the stock fitting attaches at a angle that is not parallel to the rails. You should post a pic once it's all installed.

Sponsored

 

[10r80]

That will work too, the only thing is im not sure if the stock feed line will reach that spot on the front drive sider, even with the nitrous adapter the stock fitting attaches at a angle that is not parallel to the rails. You should post a pic once it's all installed.

Yeah it doesn't seem like there is too much slack on that feed line. Putting the rails on tonight so we'll see.

 

[Toy Cobra]

 

[Toy Cobra]

It would be nice it it had a direct connection line the Fore unit...

 

[gimmie11s]

It would be nice it it had a direct connection line the Fore unit...

That is set up to dead head and wouldn't work in this application without further changes to the plumbing..

He is running a return system.

 

[Toy Cobra]

Valid point I was just noting the rail with the fitting on it in the correct location.

 

[10r80]

Am I going to have any issues with the cross over hose like that?
The injector connectors were annoying...And the pressure sensor itself looks to be the same size as the open npt port on the slr rail so no adapter fitting needed, just need to extend the harness now. Wish it was on the same side.
Best and fastest way to contact Sai Li is by phone, super helpful

 

[Kona 18]

You have have any issues with the cross over like that, I would personally cut the hose shorter so it doesn't stick up as much, but thats more for aesthetics than it is for function

 

[10r80]

Cut here and crimp right side of yellow wire to the blue wire?

Sponsored