Lol, putting the car on strength training
That's probably what his family has been saying too, super expensive lego/tetris going on.
That was my thought, too. Must be planning to turn it into a monster.
Something solid for sure. But, I really bit off a big project with this in the middle of the move. Not the smartest way to do this lol. I'll put my nose down and do my best to move this along.That was my thought, too. Must be planning to turn it into a monster.
Looking forward to the updates.
Not hard. Just a small space to work in. I left the two slip-on pedal covers in the sun for about 30 minutes to get the rubber part soft and pliable. Then I work them on with hand strength and a small flat head. The accelerator is just bolt up and plug. I also installed a new clutch spring at the same time.
No I bought RF2s but I think they are out of stock and discontinued +30 offset and HyperBlack as an option, but I found some listings for RF1s in that spec through Ebay in case my purchase falls through and was asking you guys your opinion on the design look. I also think the listings I am finding are probably inaccurate as well. My last option was to get some Work replicas (heavier than the ESR rotary forged) but almost all of them come in 19X10.5 +22 and will only fit with tire stretch and lots of camber...not really interested and defeats my goals. However, 19x9.5 with either +22 or +35 is available but aren't in my goals of 10 or 10.5 width....alas, first world problems. The 19x9.5 at +22 actually tucks pretty well on a 275 40 or 285 35 (tire brand dependent).
