boos550t
Well-Known Member
That splitter looks pretty good. How far does it go back under the car? Does it go past the mounting points where it meets the belly pan?Fitment was spot on, came with all the necessary hardware, you have to use your existing hardware as well. I did not have to relocate my ACC sensor and it works perfectly like factory, major plus for me.
Vicrez customer service was pretty good. I should mention that you will need a base belly pan for better installation. For PP it will not line up properly. Depending on who is installing it, you or the shop, there are limited instructions out there, but it’s not hard to figure out. Just YouTube “GT500 bumper” and a few videos will get you in the right track. Overall I am very pleased with my bumper and would not do anything different except spray the insertion tabs with some speed shine so the go in easy.
Also, as a courtesy for my troubles Vicrez sent me a very nice and well built splitter for it. Think it looks decent, even though I am not a fan of splitters on splitters on splitters....and it does provide
protection so I am happy about that.
Sponsored