Chumley
Well-Known Member
Anyone run into any references to backup camera initialization in FORScan?
Figured the $40 for a replacement camera module was INFINITATELY preferable than leaving the car with the dealer for the day so I swapped my defective (recalled) module myself. Took all of 5 minutes.
Problem is the lines are gone. Did the disconnect battery, check settings, drive the car for a while, etc. suggestions I found online. Read there was something the dealer does do involving software so I thought I'd ask here.
I suspect there's something in coding that ties the camera to the steering angle sensor or something in Sync that needs resetting. Any suggestions would be much appreciated.
Figured the $40 for a replacement camera module was INFINITATELY preferable than leaving the car with the dealer for the day so I swapped my defective (recalled) module myself. Took all of 5 minutes.
Problem is the lines are gone. Did the disconnect battery, check settings, drive the car for a while, etc. suggestions I found online. Read there was something the dealer does do involving software so I thought I'd ask here.
I suspect there's something in coding that ties the camera to the steering angle sensor or something in Sync that needs resetting. Any suggestions would be much appreciated.
Sponsored