moodywizard
Well-Known Member
After reviewing the instructions on steeda web site, Bushing reinforcement collar (the oval looking one) does it still have the bolts in it that keep it together? If so would you take 50 shipped?
below is from the instructions.
"Bushing reinforcement collar installation: While the rear main bolts
are still loose, install the bushing reinforcement collars on both rear
sub frame mounts. The short side of the collar, goes in towards the
center of the car. Install that side first, then install the longer side of
the collar.
Note: Lubrication may be needed to slide the collar into
place.
The groove in the collar faces up, towards the body of the car.
Once the collar is placed into position, install the provided bolts, and
tighten until the collars are flush with each other. Make sure the two
halves are lined up correctly before threading the bolts in, to keep
from cross threading. See figure 5."
below is from the instructions.
"Bushing reinforcement collar installation: While the rear main bolts
are still loose, install the bushing reinforcement collars on both rear
sub frame mounts. The short side of the collar, goes in towards the
center of the car. Install that side first, then install the longer side of
the collar.
Note: Lubrication may be needed to slide the collar into
place.
The groove in the collar faces up, towards the body of the car.
Once the collar is placed into position, install the provided bolts, and
tighten until the collars are flush with each other. Make sure the two
halves are lined up correctly before threading the bolts in, to keep
from cross threading. See figure 5."
Sponsored
