Front control arm bearing/arm twist

[strengthrehab]

Anyone experience this? This has happened on LF 2x now. RF is fine. I can pry it back into upright position.

Bearings/arms are Steeda pieces. I've contacted them a d awaiting word.

Anyone else experience this?

Sponsored

 

[Danmg202]

Not sure if I have the right perspective but it looks like your snap ring is on the opposite side of mine.

 

[Danmg202]

Huh

 

[strengthrehab]

I can't explain that, lol. I know my arms were marked L and R and others I've seen has shown the lock ring on the inboard side, but who knows.

 

[Danmg202]

I can't explain that, lol. I know my arms were marked L and R and others I've seen has shown the lock ring on the inboard side, but who knows.

Well looking at other ones your right, my arms are on the correct sides but trying to follow the instructions I have my bearings in backwards. Ugh what a pain.

 

[JimiClutch]

You figure anything out? I just installed these myself but haven’t driven on them yet

 

[decableguy2000]

Just installed these a couple of weeks a go. Now I have to crawl a round on wet drive and look.. Did you install just the bearings or the whole arm?

 

[Danmg202]

All I figured out is every picture or video of a pressed in install I found ended up on the same side as mine while the steeda pre installed ones are on the other.

 

[JimiClutch]

Just installed these a couple of weeks a go. Now I have to crawl a round on wet drive and look.. Did you install just the bearings or the whole arm?

I bought the complete arm from Steeda

Sponsored